OPW Petro Vend 200 M1010, Инструкция по установке, эксплуатации и обслуживанию

Страница: 32 / 98

1. Make sure the unit is turned on.
2. Remove the roll of paper (54-1107) from its protective material.
3. Put the roll of paper in the paper tray.
NOTE: Paper must feed from the TOP of the roll so the thermal sensitive side is up.
4. Feed the paper into the printer through the paper guide slots. The sensor in the paper guide will sense
the paper and start the printer to automatically load the receipt paper.
IMPORTANT: If the printer starts, but does not automatically load the paper, push the paper
release lever and feed the receipt paper until the paper advances.
5. Pull out the extra paper in the chute to cut it off.
7.3 Clear a Paper Jam
To clear a paper jam, cut off the document that is jammed in the eject chute and remove the paper.
To completely remove the remaining paper in the chute:
1. Turn the unit OFF before clearing the paper jam.
2. Push the paper release lever (see the image above).
3. Manually pull the paper out of the printer chute.
NOTICE: To prevent damage to the print head, never push this lever while the printer is in
operation!
4. If paper remains in the print mechanism and the eject chute it can be removed manually:
Doc. No.: M1010 Rev.: 10
Page 32 of 98