OPW Petro Vend 200 M1010, Инструкция по установке, эксплуатации и обслуживанию

Страница: 92 / 98

gasket against the top edge of the slot to install the 13.25 inch piece. The right edge of this gasket
piece will end flush with the edge of the 17 inch piece on the right. Make sure you do not stretch the
gasket.
IMPORTANT: The top of the 13.25 inch piece must align with the top of the frame as shown in
the photo above. There will be a gap between the bottom of the gasket and the bottom of the
frame. DO NOT TRY TO STRETCH THIS GASKET TO THE BOTTOM!
Completed Gasket Assembly
11. Install the Door Assembly back on the enclosure.
12. Attach the Ground Strap back on the enclosure Ground Post with the wingnut.
13. Put the wires of the Power Supply harness back in the cable clamp and connect the Molex plug back
to the J16 connector on the Main Board.
14. Push the Terminal rocker switch on the Power Supply to the | position to energize the unit.
Doc. No.: M1010 Rev.: 10
Page 92 of 98