OPW Petro Vend 200 M1010, Инструкция по установке, эксплуатации и обслуживанию

Страница: 75 / 98

IMPORTANT: Refer to "Integrated FSC Communication Conduit" on page 26 for information
on conduit requirements for internal FSC3000 Ethernet communication.
Your DX Fleet option kit has these components:
l
Vantron/Edge - 5-port Ethernet Switch Assembly
l
2 x 8-32 KEPS nuts (FMS P/N 50-0008)
l
18" Black CAT5e Patch Cable (FMS P/N 12-3005-018-BLK)
l
6" RJ45 Patch Cable (FMS P/N 12-3031)
l
RJ45 TO DB9 Cable (20-1520-01)
l
USB to Seial Port Adapter Cable (75-2030)
20-1722 FSC3000/PV200 Power Cable
IMPORTANT: You must have a 20-1722 Revision 5 (or above) cable installed before you can
install the DX Fleet option. The Revision 5 cable can be identified by the Red and Black wires
attached to the 4-pin connector that is connected to the Petro-Net Hub. The Red/Black wires
terminate at two (2) 2-pin connectors to supply electrical power to the Vantron/Edge and 5-
port Ethernet Switch.
If your terminal does not have this cable, call Customer Support at
888-OPW-FUEL (888-679-3835) to purchase the latest revision of the cable.
To replace the 20-1722 (revision 0-4) cable:
Disconnect the FSC3000 cable harness from the Power Supply:
1. AC Out (terminal block with Black/White/Green wires).
Doc. No.: M1010 Rev.: 10
Page 75 of 98