OPW M00-051.00 FSC3000, Руководство по настройке через командную строку

Страница: 87 / 181

13.3 Set Odometer Reasonability
The Set Odometer Reasonability table is where the ranges for the odometer reasonability feature are
defined. Each code is assigned a minimum and maximum mileage range. This range is then assigned to
either Single or Vehicle Cards. When a transaction is performed, the currently entered odometer is checked
against the previously stored odometer within the FSC3000
™
card file. The difference is then compared
against the odometer reasonability table with the code defined for that card. If the mileage traveled is equal to
or above the lower range and equal to or below the upper range, the odometer is considered reasonable and
the transaction will continue. If the transaction mileage is higher than the upper limit, or lower than the lower
limit, the transaction mileage entry is considered unreasonable and the system will respond in one of the two
ways:
l
Accept the third bad entry and fueling is allowed (bad odometer saved)
l
Reject the third bad entry and terminate transaction
(Option 2) – Card/Account options
Card/Account Buffer – The "Odometer Reasonability" option must be enabled in order to use this setup
option.
NOTE:
Code 0 assigned to a card will ignore reasonability.
To set Odometer Reasonability Table type:
Set Odometer Reasonability <ENTER>.
1) Enter MINIMUM mileage: 0
2) Enter MAXIMUM mileage: 100
3) Enter MINIMUM mileage: 0
4) Enter MAXIMUM mileage: 250
5) Enter MINIMUM mileage: 0
6) MAXIMUM mileage: 500
14) Enter MINIMUM mileage: 150
Enter MAXIMIM mileage: 700
15) Enter MINIMUM mileage: 150
Enter MAXIMUM mileage: 10000
Change action after BAD Odom entries (Y/N)? y
Allow fueling if 3 BAD Odom entries (Y/N)? N
NOTE:
PetroLink™ transactions using Odometer Reasonability will always deny fueling
when out of range, irrelevant of the above setting – allow fuel if BAD odometer entry.
In order to use Odometer Entries when Tiered Accounts is enabled, set all minimum values to zero (0) and
maximum to nine (9) if Odometer Reasonability and Multiple Locations are not in use. If Odometer
Reasonability is in use, then the Tier and Odometer Reasonability table are shared when using codes 1-20.
Doc. No.: M00-051.00 Rev.: 10
Page 87 of 181