![background image](http://html1.mh-extra.com/html/omron/srm1-programing-02-2001/srm1-programing-02-2001_programming-manual_742414118.webp)
2-5
Section
CPM2A/CPM2C Pulse Output Functions
97
2-5
CPM2A/CPM2C Pulse Output Functions
The CPM2A/CPM2C has two pulse outputs. By means of a selection in the PC
Setup, these outputs can be used as two single-phase outputs without accelera-
tion and deceleration, two variable duty ratio pulse outputs, or pulse outputs with
trapezoidal acceleration/deceleration (one pulse + direction output and one up/
down pulse output). The pulse output PV coordinate system can also be speci-
fied in the PC Setup as either relative or absolute.
There are two pulse output modes: Independent mode, in which outputs are
stopped at a preset amount of pulses, and continuous mode, in which outputs
are stopped by an instruction.
Note
To use pulse outputs, it is necessary to use a CPU Unit with transistor outputs,
i.e., either a CPM2A-
CDT-D or CPM2A-
CDT1-D.
The following diagram shows the configuration for a CPM2A, but the configura-
tion for a CPM2C is identical.
Stepping motor
Pulse outputs
Motor
controller
Item
Single-phase
pulse outputs
i
Variable duty
ratio pulse
Single-phase pulse outputs with trapezoidal
acceleration/deceleration
pu se ou pu s
without
accel/decel
a o pu se
outputs
Pulse + direction
outputs
Up/down pulse
outputs
Execution instructions
PULS(65) and
SPED(64)
PWM(––)
PULS(65) and ACC(––)
Output
number
01000
Pulse output 0
(See note 1.)
Pulse output 0
(See note 1.)
Pulse
output 0
Pulse output
Pulse
output 0
CW pulse
output
u be
01001
Pulse output 1
(See note 1.)
Pulse output 1
(See note 1.)
ou pu 0
Direction
output
ou pu 0
CCW pulse
output
Output frequency range
10 Hz to 10 kHz
0.1 to 999.9 Hz
10 Hz to 10 kHz
10 Hz to 10 kHz
Pitch
10 Hz
0.1 Hz
10 Hz
10 Hz
Up/down frequency pitch
---
---
10 Hz (See note 2.)
10 Hz (See note 2.)
Start speed pitch
---
---
10 Hz
10 Hz
Output mode
Continuous,
Independent
Continuous
Continuous,
Independent
Continuous,
Independent
Number of
pulses
1 to 16777215
---
±
1 to 16777215
±
1 to 16777215
Duty ratio (See note 3.)
50%
0 to 100%
50%
50%
Control
method
Movement
specification
Yes
No
Yes
Yes
e od
Accel/decel
specification
No
No
Yes
Yes
Start speed
specification
No
No
Yes
Yes
Duty
specification
No
Yes
No
No
Содержание SRM1 - PROGRAMING 02-2001
