Oce Arizona T220UV, Руководство пользователя

Страница: 98 / 114

98 T220UV User Guide
Monthly Maintenance
Clean Gantry Rails
Introduction
Dust and debris can accumulate on the gantry rails, which run along the length of the table. The bearings that run on the rails
are equipped with shields that are designed to keep debris from entering the bearing housing. After a period of time and use,
debris can accumulate on the outside of the bearing shields as the gantry traverses the table.
When to do
If you notice any dirt or ink on the gantry rails, or an accumulation of debris on the rails bearings, clean them immediately.
Required tool
Poly-Wipe lint-free Cloth
Attention:
In the event of an ink spill on the rail, it should be cleaned immediately, before the bearings have a chance to run
over the spill. After the area has been cleaned, wipe the spill area again thoroughly with a watermoistened lint-free cloth
to remove any chemical residue before running the gantry over the area again. Slight ink stains that remain on the rail after
cleaning are not a major problem.
How to Clean the Rails
1.
Power OFF the T220UV at the AC power On/Off circuit breaker switch located at the side of the electronics enclosure.
2.
Turn the Lockout switch to the horizontal position and apply a lock.
3.
Use a dry lint-free cloth to remove all visible debris that has accumulated next to the bearing shields. It is only necessary to
clean the outside bearing shields. When removing debris always wipe away from the shields.
4.
Remove the lock from the Lockout switch.
5.
Power ON the T220UV.