Oce Arizona T220UV, Руководство пользователя

Страница: 49 / 114

How to Operate the Arizona T220UV 49
Change Print Job Parameter Options
Introduction
The print job parameter options consist of three functions that support printing. If a particular option was enabled in the
Operator\Enable Job Parameters Change menu, and if the operator decides to change the settings of a selected print job, then
its associated screen is displayed in the following order.
■
BiDirectional Printing - either in both directions or just right to left
■
# of Copies - print up to 100 copies of an image
■
# of Overprints - prints the image on the media up to 3 times
Purpose
The Operator\Print Parameters menu lets you set Enable Job Parameter Changes to ON or OFF. If this is set to ON, you can
decide which of the three options are presented to the operator prior to printing. If this is set to OFF, then the options will
not appear in the display when the operator chooses to change the other settings in a selected print job.
Note:
Use the MENU key to move to the next option if no changes are required for a particular parameter.
Change Print Direction
1.
Press + or - to change the printing direction. Options are Single or Bidirectional — single means that the nozzles will print
only in the right to left direction, while bidirectional prints in both directions.
2.
Press ACCEPT when the printing option you want is displayed.
Change Number of Copies
1.
Press + or - to change the number of copies printed. Options are 1 to 100. Use the ACCEPT key to move through the
displayed digits. The selected digit has an underline indicating it can be increased or decreased using the + or - keys.
2.
When the digit you want is displayed, press ACCEPT and the underline moves to the next digit.
3.
When you are at the last digit, press ACCEPT to choose the number of copies that is displayed. The display will advance to
the Overprints display (if enabled).
Change Overprints
1.
Press + or - to change the number of times the image prints on top of itself. Options are 1 to 3. Use the ACCEPT key to move
through the displayed digits. The selected digit has an underline indicating it can be increased or decreased using the + or -
keys.
2.
When the digit you want is displayed, press ACCEPT and the underline moves to the next digit.
3.
When you are at the last digit, press ACCEPT to choose the number of overprints. The display advances to the Place Media
menu.
Place Media Menu
1.
Press the VACUUM button on the control panel to turn on the vacuum system that holds the media in place for printing.
2.
Press ACCEPT and the gantry will move to position itself over the media.
Note:
Printing may not start immediately as the UV lamps must warm up to print temperature so that they can cure the
UV-based ink used for imaging on the media.
When printing begins, the image start point is the lower left corner of the image.