Oce Arizona T220UV, Руководство пользователя

Страница: 67 / 114

Ink System Management 67
How to Scan Ink Barcodes
Introduction
Whenever you replace an ink bottle, scan the new bottle’s barcode. The T220UV printer calculates the amount of ink used
for each color printed and determines approximately when the volume for a bottle of each color ink is finished. It also retains
a record of previous barcodes. If you are prompted to enter the barcode from a bottle of ink you may not necessarily have
an empty ink bottle. If you changed the ink bottle without a barcode scan, eventually you will see the following display on
the control panel: "Ink Barcode expired Press ACCEPT to continue".
Illustration
[17] Barcode Wand
[17] Barcode Wand
Scan a Barcode
1.
Navigate to the Operator\Ink menu and select the color of ink to change/install. Press ACCEPT to continue and you will see
the following display: "Scan barcode (color XXX) ACCEPT -> Manual Entry".
2.
Use the barcode wand located under the Control Panel to scan the barcode on the ink bottle. When the scan is successful,
the following confirmation display appears for a few seconds, then printing can continue: "Scan Barcode: Light magenta
RGIBC: xxxxxxxx".
Note:
(Tip: hold the wand at a 45 degree angle while moving smoothly at a constant rate across the barcode).
Manual Entry of Barcode
1.
Press ACCEPT during the Scan Barcode ACCEPT -> Manual Entry display to access the manual barcode routine.
2.
Look up the string of digits located below the bar code on the ink botle, and enter them one at a time. Use the + and - keys
to cycle through the digits until you see the one you need.
3.
Press ACCEPT to move to the next blank space and select the next digit.
4.
When the last barcode digit is entered, press ACCEPT and the control panel displays: "Scan Barcode: color/ RGIBC: xxxx"
(where xxxx is the barcode you just entered). After this confirmation, the printer can resume printing.