Oce Arizona T220UV, Руководство пользователя

Страница: 35 / 114

User Interface 35
Arizona T220UV Lamp Control
The UV lamps are necessary for drying the ink. When the lamps are on it is essential to follow the safety precautions
indicated in “UV Safety” on page 9, since the UV light is potentially harmful if safety protocol is not followed. This section
explains the different states of the lamps and how they relate to the operation of the printer.
[17] UV Lamp States
[17] UV Lamp States
Start of a print: Once the lamps are struck, it generally takes about 2 minutes in a warm up state for the lamps to reach their
target power level. When the lamps attain their target power level, the print will not begin until the illuminator temperature
reaches 125C (257F). There is a 7-minute warm up time-out, which will cause the print to abort and give an error message.
If the lamps begin at their idle power level and are set to go to their print power level, this change only takes a few seconds.
After a print: When the carriage is parked, the lamps will go into an idle power mode currently defaulted to 30%. The lamps
will remain at this power level until the idle timeout occurs, currently defaulted to 10 minutes. Both of these settings are menu
adjustable. After the time-out period, the lamps will be turned off.
Stage Description
Lamp off When the printer is idle, the carriage is parked, and the lamp is inactive, the status of the lamp will
be displayed as "Off".
Lamp cooling When the lamp is off, but has been used recently, the lamp will go into a "cooling" state waiting for
the illuminator sensors to drop below 31C (88F).
Lamp warmup When a print is requested and the lamp is currently off, the lamp will strike and go into a "warmup"
state.
Lamp power XX% When the lamp is running, the target "power" will display in percent.