Oce Arizona T220UV, Руководство пользователя

Страница: 82 / 114

82 T220UV User Guide
System Errors
Introduction
System errors stop the printer and prevent operation until the error is resolved. Many system error messages indicate the
source of the problem and state that the error can be cleared by pressing the ACCEPT button on the control panel.The
following table contains some of the common printer errors. There are other errors, and generally the message provides you
with an idea of the problem and how to solve it. If the problem persists or if you are unsure of how to proceed, record the
error message and contact your Océ service representative.
T220UV Error Messages
[24] Error Messages
[24] Error Messages
Error Message Possible Cause and Response
“WARNING: SAFETY INTER-
LOCK BYPASSED” Refer to possible causes in section “Emergency Stop” (see ‘ Operator Control Panel ’
on page 32 )
"SYSTEM ERROR
[press ACCEPT to restart]"
"BLOTTER MOTOR or EN-
CODER" The blot cloth is not moving.
Might be out of cloth or stuck.
"Lamp Warmup timeout. Cancel-
ling print"
"Press ACCEPT to Continue" The illuminator could not reach its minimum temperature (default 120F/49C ) in its
allotted time (10 minutes).
Might be a sensor problem or bad cabling - call for service.
“Lamp xx is out, uv power is off”
“press ACCEPT to continue” The lamp(s) have unexpectedly gone off. This error should be recorded, but no action
is required unless the problem is persistent.
If persistent, a service call is in order.
“Reflector overtemp interlock
open”
“press ACCEPT to continue” Illuminator over-temp pop out has triggered. Possible problem with illuminator fan or
other cooling problem. Check that the lamp is on and also that the carriage fan is
plugged into the carriage cover and the gantry fans are all running.
If problem persists, call for service.
“Carriage temp is too high” “print
cancelled, press ACCEPT” The carriage temperature has exceeded its maximum range. There may be a fan not
working or other mechanical failure relating to the cooling system (air flow). The
printer may also be printing above its operating range. Check that the room temper-
ature is not too high and that all fans are working.
"Carriage out of safety zone"
"press ACCEPT to continue" The carriage has stopped with its lamps on in the middle of the gantry.
If problem persists, call for service.