Oce Arizona T220UV, Руководство пользователя

Страница: 47 / 114

How to Operate the Arizona T220UV 47
Change Print Job Settings
Introduction
The following three settings may be altered only if the operator chooses to change them when the print information for a
particular job is displayed by pressing the + or - keys:
• Media Thickness
• UV Power Setting
• Horizontal and Vertical Offsets
Purpose
If you p or - when the print job information was displayed, you can change settings in the print job.
When to do
The desired media thickness is first set when you prepare the image in PosterShop and then verified at the control panel prior
to printing. As a precaution against damaging the printheads, there is a media touch rotary switch located on the lead edge
of the carriage used to detect any obstacles higher than the media on the table. If anything on the table is sitting too high,
including the media, the media touch rotary switch will cause the gantry to stop and the control panel will alert the operator
of the problem.
Note:
Do not rely on media thickness specifications listed on the media supply box. Always measure the media with a digital
caliper (see below) to be sure of the correct height.
In the second menu display you can change the power setting of the UV lamps. A higher setting results in faster drying of
the ink but also applies more heat to the media.
The third menu display allows you to change first the horizontal and then the vertical offsets. This determines where the
image is printed on the media.
Required tool
ODGS recommends that the operator measure the media thickness with a set of calipers.This ensures optimum conditions
for achieving the best possible print quality by placing the print nozzles at the optimal height above the media. Since the
clearance between the media and the print heads is only 2mm (0.08 in.), altering the clearance has a negative impact on the
bi-directional alignment.
Change Media Thickness
1.
Use the ACCEPT key to move through the displayed digits. The selected digit has an underline indicating it can be increased
or decreased using the + or - keys.
2.
When the digit you want is displayed, press ACCEPT and the underline moves to the next digit.
3.
When you are at the last digit, pressing ACCEPT advances to the Offests menu.
Note:
Use the MENU key to move to the next digit if no changes are required for a particular field.