Oce Arizona T220UV, Руководство пользователя

Страница: 73 / 114

Media Management 73
How to Use Media Holder Strips
Introduction
Some media, such as Fome Cor, has a tendency to warp off the table when subjected to heat. This warpage can result in a
carriage collision. Media Holder Strips — which are shipped with the printer — help to limit this possibility. Six strips may
be required to border the long edges of a sheet of 4'x8' Fome Cor.
The media holder strips are 1/8" (3.2mm) thick. When using media with the media holder strips, 3/16" (4.8mm) thick
material should be used.
■
The strips can be printed on if a bleed is required in the image. If the strips are used for a bleed and the media thickness
is more than 2mm greater than the strips, overspray and nozzle dropout is likely to occur.
■
When not in use, the strips should be stored flat.
Purpose
The sharp edge of the media holder strip butts up against the middle of the edge of the media. This prevents warping and
increases the effect of the vacuum.
Attention:
If you use the strips, make sure you do not use any media less then the thickness of the media holder strips.
Caution:
Do not print on mirrors or any other highly reflective media as UV light is reflected off such media. This results in
curing the ink in the heads and thus damaging them.
Illustration
[22] Foam Cor with Media Hold-Down Strip
[22] Foam Cor with Media Hold-Down Strip