248
Digitax HD M753 Control User Guide
Issue Number: 3
User Program
On board user program error
249
The
User Program
trip indicates that an error has been detected in the onboard user program image. The reason for the trip
can be identified by the sub-trip number.
Trip
Diagnosis
Sub-trip
Reason
Comments
1
Divide by zero
2
Undefined trip
3
Attempted fast parameter access set-up with non-existent
parameter
4
Attempted access to non-existent parameter
5
Attempted write to read-only parameter
6
Attempted an over-range write
7
Attempted read from write-only parameter
30
The image has failed because either its CRC is incorrect,
or there are less than 6 bytes in the image or the image
header version is less than 5.
Occurs when the drive powers-up or the image is
programmed. The image tasks will not run
31
The image requires more RAM for heap and stack than can
be provided by the drive.
As 30
32
The image requires an OS function call that is higher than
the maximum allowed
As 30
33
The ID code within the image is not valid
As 30
40
The timed task has not completed in time and has been
suspended
Onboard User Program: Enable
(11.047) is reset to
zero when the trip is initiated
41
Undefined function called, i.e. a function in the host system
vector table that has not been assigned.
As 40
52
Customized menu table CRC check failed
As 30
53
Customized menu table changed
Occurs when the drive powers-up or the image is
programmed and the table has changed. Defaults
are loaded for the user program menu and the trip
will keep occurring until drive parameters are saved.
80
Image is not compatible with the control board
Initiated from within the image code
81
Image is not compatible with the control board serial
number
As 80
100
Image has detected and prevented attempted pointer
access outside of the IEC task's heap area.
101
Image has detected and prevented misaligned pointer
usage.
102
Image has detected an array bounds violation and
prevented its access.
103
Image has attempted to convert a data type to or from an
unknown data type, has failed and has shut itself down.
104
Image has attempted to use an unknown user service
function.
200
User program has invoked a "divide" service with a
denominator of zero. (Note that this is raised by the
downloaded image and has therefore been given a distinct
error code despite being the same fundamental problem as
sub-trip 1.)
201
Parameter access is not supported. An attempt to read
database other than the host drive.
202
Parameter does not exist. Database was host drive but the
specified parameter does not exist.
203
Parameter is read-only.
204
Parameter is write-only.
205
Unknown parameter error.
206
Invalid bit present in parameter. The parameter does not
contain the specified bit.
207
Parameter format lookup failed. Failed to get parameter
information data.
208
An over-range write has been attempted.
Содержание Digitax HD M753 EtherCAT
Страница 261: ......
Страница 262: ...0478 0461 03...