NEC Express5800/140Rf-4, Руководство пользователя

Страница: 293 / 461

Troubleshooting 8-29
Beep Codes
If an error occurs during the POST, the server beeps, indicating the type of error.
Each number indicates the number of short beeps, and a hyphen indicates a pause. For example, the
beep interval 1-3-1-3 indicates 1 beep, pause, 3 beeps, pause, 1 beeps, pause, and 3 beeps notifying
that the keyboard controller error.
Beep code Description Recommended action
1-2 Video BIOS initialization
error If nothing is displayed, check if the connector of the
display unit is properly connected. If the error persists,
contact your service representative to replace the
base board.
If an expansion of Option ROM for additionally
installed PCI board is not displayed, check if the PCI
board is properly installed. If the error persists, contact
your service representative to replace the base board
or PCI board.
1-2 Option ROM initialization
error
1-3-3-1 Memory is not detected.
Or, DIMM type is
incorrect. Check if the DIMM and memory boards are properly
connected. If the error persists, contact your service
representative to replace DIMM or memory board.
1-3-4-1 DRAM Address error
1-3-4-3 DRAM test Low Byte
error
1-4-1-1 DRAM test High Byte
error
1-5-1-1 Processor fails to start. Check if the processor is properly installed. If the error
persists, contact your service representative to
replace processor or base board.
1-5-2-2 No processor error
1-5-2-3 Processors of various
types and voltages
coexist. Check if the additionally installed processor is
supported by the server. Check also the installation of
processor. If the error persists, contact your service
representative to replace the processor or base board.
2-2-3-1 Unexpected interrupt test
error Contact your service representative to replace the
base board.
NOTES:
„
Beep code 1-5-4-2 informs you that AC power supply is interrupted
due to power failure or momentary voltage drop and the system is
restarted. This is not an error.
„
The SAS riser board emits beep sound for one second or so
immediately after system power-on or reset, it is not an error.