NEC Express5800/140Rf-4, Руководство пользователя

Страница: 124 / 461

4-26 Configuring Your Server
Option Parameter Description Your Setting
Boot
Monitoring [Disabled]
5 minutes
10 minutes
15 minutes
20 minutes
25 minutes
30 minutes
35 minutes
40 minutes
45 minutes
50 minutes
55 minutes
60 minutes Indicates whether the boot monitoring
function is enabled or disabled on booting.
To use this function, install NEC ESMPRO
Agent. Do not use this function if the system
is booted from OS without installation of NEC
ESMPRO Agent or CD-ROM. Set this item to
"Disabled" if ARCServe uses the Disaster
Recovery Option.
Boot
Monitoring
Policy [Retry 3 Times]
Always Retest Appears when the boot monitoring feature is
enabled. This item indicates the processing
at the occurrence of timeout during boot
monitoring.
If [Retry 3 times] is selected, the system is
reset after the occurrence of timeout and OS
boot is retried up to three times.
If [Always Reset] is selected, the system is
reset after the occurrence of timeout and OS
boot is retried repeatedly.
Thermal
Sensor Disabled
[Enabled] Indicates whether the temperature sensor
monitoring function is enabled or disabled.
BMC IRQ Disabled
[IRQ 11] Indicates the IRQ of the BMC interrupt.
Post Error
Pause Disabled
[Enabled] Indicates whether POST is aborted once at
the end of POST if an error occurs during the
execution of POST.
AC-LINK Stay Off
[Last State]
Power On
Indicates the AC-LINK function. Shows the
state of the power of the server.
Power ON
Delay Time [20] - 255 Sets the power on delay time when "Power
On" or "Last State" is specified for AC LINK.
Platform
Event
Filtering Disabled
[Enabled] Enables or disables the Platform Event
Filtering feature of the baseboard
management controller (BMC).
[ ]: Factory-set
The table below shows the operation when the AC power to the server is turn off once and then on
again, depending on the setting of "AC-LINK."
System status before AC power off
Setting of AC-LINK
Stay Off
Last State Power On
Operating Off On On
Aborting (DC power being off also) Off Off On
Forced shutdown Off Off On
* Press the POWER/SLEEP switch continuously at least four seconds. This forcibly turns off the
power.
IMPORTANT:
Set this item to "Power on" in order to link the AC
power source supplied from UPS when the server is connected to UPS.