NEC Express5800/140Rf-4, Руководство пользователя

Страница: 192 / 461

4-94 Configuring Your Server
CONFIGURING BASE BOARD JUMPERS
With the pre-installed SETUP utility, you can set desired passwords to protect the data stored in the
server against access from unauthorized users. When you forget the passwords, however, you may
want clear them. The following describes how to clear these passwords. You can also use the
following procedure to clear the CMOS data in the server.
IMPORTANT:
„ Clearing the CMOS data resumes the factory-set configuration data.
„ Use the clip over jumper pins (pins 1 and 2) on the base board.
„
Place the clip over the jumper pins 1 and 2 after use to keep the pin.
Placing the clip over any other pins may cause malfunction of the
server.
„ Do not change any other switch settings. Any change may cause the
server to fail or malfunction.
„
Do not lose the clip.
To clear passwords or the CMOS data, use the jumper switch on the base board of the server.
The following describe the clearing procedure.
WARNING
Do not disassemble, repair, or alter the server.
Never attempt to disassemble, repair, or alter the server on any occasion other
than described in this manual. Failure to follow this instruction may cause an
electric shock or fire as well as malfunctions of the server.
The following figure illustrates the jumper switch location.
Jumper clip
Jumper clip
Pins for
protecting/clearing the
CMOS data
Pins for protecting/clearing
the passwords.