APPENDIX E REVISION HISTORY
User’s Manual U16898EJ3V0UD
409
(3/4)
Edition Description
Applied
to:
Modification of
11.4.2 (2) (h) SBF transmission
Modification of
Table 11-4 Set Data of Baud Rate Generator
CHAPTER 11 SERIAL
INTERFACE UART6
Addition of
Caution
to and modification of
Table 12-1 Interrupt Sources
CHAPTER 12
INTERRUPT
FUNCTIONS
Modification of description on operation stop time in
13.1.1 (2) STOP mode
Modification of
Table 13-2 Operating Statuses in HALT Mode
Modification of
Remark 2
in
Figure 13-2 HALT Mode Release by Interrupt Request
Generation
Modification of
Note
in
Figure 13-3 HALT Mode Release by Reset Input
Modification of
Caution
in
13.2.2 (1) STOP mode setting and operating statuses
Modification of
Table 13-4 Operating Statuses in STOP Mode
Modification of operation stop time in the following figures.
•
Figure 13-4 Operation Timing When STOP Mode Is Released
•
Figure 13-5 STOP Mode Release by Interrupt Request Generation
CHAPTER 13
STANDBY FUNCTION
Modification of the following figures
•
Figure 14-1 Block Diagram of Reset Function
•
Figure 14-2 Timing of Reset by RESET Input
•
Figure 14-3 Timing of Reset by Overflow of Watchdog Timer
•
Figure 14-4 Reset Timing by RESET Input in STOP Mode
Addition of registers to be used for self programming function in
Table 14-1 Hardware
Statuses After Reset Acknowledgment
CHAPTER 14 RESET
FUNCTION
Addition of
Note 1
to
Figure 16-2 Format of Low-Voltage Detect Register (LVIM)
Addition of
Note
to
Figure 16-3 Format of Low-Voltage Detection Level Select
Register (LVIS)
Addition of
Notes 1
and
2
to and modification of
Figure 16-4 Timing of Low-Voltage
Detector Internal Reset Signal Generation
Addition of
Notes 1
and
2
to and modification of
Figure 16-5 Timing of Low-Voltage
Detector Interrupt Signal Generation
Addition of
Note
to
16.5 Cautions for Low-Voltage Detector <Action> (2) When used
as interrupt
CHAPTER 16 LOW-
VOLTAGE DETECTOR
Revision of
CHAPTER 18 FLASH MEMORY
CHAPTER 18 FLASH
MEMORY
2nd edition
Modification or addition of values in the following characteristics in
CHAPTER 20
ELECTRICAL SPECIFICATIONS (TARGET VALUES)
•
Absolute maximum ratings
Output current high, output current low, and operating ambient temperature
•
X1 oscillator characteristics
•
Low-speed internal oscillator characteristics
•
DC characteristics
•
AC characteristics
(1) Basic operation cycle time (minimum instruction execution time), RESET input
low-level width
•
POC circuit characteristics
Condition for power supply boot time
•
Flash memory programming characteristics
CHAPTER 20
ELECTRICAL
SPECIFICATIONS
(TARGET VALUES)
