Installing Washify Controller Integration
Table of Contents.
1.
Mounting the Enclosure
Step 1. Metal Fins
Step 2. Lag Fins to the Wall
Step 3. Verify Mounting
2. Providing Power and Network
Step 1. Locate and Identify wire fittings
Step 2. Running Network/Cat Cable connection
Step 3. Tighten Network/Cat Cable fitting
Step 4. Terminate Network/Cat Cable
Step 5. Test Network/Cat cable
Step 6. Connecting Network Cable to Moxa
Step 7. Run power wires
Step 8. Insert power wires
3. Wiring to controller
Step 1. Run cables from 16 Keypad Push Button Station to Integration enclosure
Step 2. Insert Common Jumper strip
Step 3. Follow diagram to connect relays to 16 Keypad Push Button Station
Step 4. Connecting Adapter to ICS 16 Button Keypad
Step 5. Controller Code assignment
Содержание MOXA
