MOTO GUZZI California EV V1100, Руководство по обслуживанию станции

Страница: 133 / 173

REMOVAL TYPE 2
•
Place a support under the motorcycle,
which allows to lift the front wheel off
the ground
•
Remove the clamps as described for
removal (1)
•
Loosen the 2 screws fixing the pin to
the fork legs
•
Remove the pin (1), the spacers (6)
and remove the wheel
Checking
BEARINGS
Before performing dimensional checks it is neces-
sary to check the state of wear of the bearings of
the wheel hub; this verification has to be done
manually with the bearing mounted in its place.
•
Turn the inner ring in both directions: it
must be able to rotate smoothly and
quietly, without jamming.
•
Then slide the inner ring out, constantly
changing position, to check for clear-
ance.
•
Remove and replace the bearings that
do not rotate smoothly and quietly or
show clearance.
CAUTION
EXCESSIVE WEAR CAN BE DUE TO VIBRATIONS AND IN-
STABILITY OF THE COMPONENT
•
To remove the bearing, use a hammer and a pin to press on the inner ring to obtain the
extraction of the bearing.
•
Move continuously the pressure point so as to obtain an extraction as linear as possible
CAUTION
THE REMOVED BEARINGS SHOULD NOT BE REFITTED
•
When refitting the new bearings control the seat, it must be free of grooves or scratches
•
Lubricate the seat before refitting the bearing, then push it into place
•
Use a tube buffer to press only on the outer ring of the bearing up to its full introduction.
CAUTION
AFTER WORKING ON THE WHEEL IT IS RECOMMENDED TO BALANCE IT
California EV V1100
Chassis
CHAS - 133