Mindray Z6, Руководство по обслуживанию

Страница: 115 / 173

Structure and Assembly/Disassembly
7-31
7.4.8 Hard Disk
NOTE
Please pay attention to the following matters during
disassembling/assembling, otherwise the hard disk will be damaged:

Hold the side of the hard disk, and please do not touch the board of the
hard disk.

Fasten the screws with the handy screw driver, and do not with the electric
screw driver.

The torsion value of the screw lock is:
M3: 4 to 6 kgf.cm
M4: 6 to 8 kgf.cm
1. Fasten one M3x12 screw removed (7.2.4.2) into the damping axis adjusting hole of display
about 2-3 rings to confirm that the screw is fixed, then pull out the monitor simultaneously
rotate the display assembly to adjust the monitor to the horizon position.
Figure 7-49 Disassembly of HDD (1)
2. Remove panhead screws with washers (5 M3X8 ) which are installed on the rack of the main
unit front cover, then remove the HDD cover assembly (including HDD cover, HDD cover
metal part and conductive foam ) to rotate display assembly to the vertical position.
Figure 7-50 Disassembly of HDD (2)
3. Remove 3 panhead screws with washers M3X6 used to secure the rack of HDD, and take out
NOTE: When rotating the monitor to horizontal position, you are sure to push damping axes
screw inward and rotate the display simultaneously.