Micromeritics Gemini VII 2390a, Руководство оператора

Страница: 344 / 426

n
v
0.014
cm
3
-------------------------
=
Appendix E Gemini VII
E-2 239-42828-01 - Dec 2012
b.) Determine the number (
n
) of glass beads needed to equal the sample volume:
where
0.014 cm
3
= approximate volume of one bead
free space cm
3
2.515
g
/
cm
3

3.53
-----------------------------------------------------------------------------
mass of glass beads g
 
=
3. Outgas the sample in the sample tube at an appropriate temperature for an appropriate amount of
time.
4. Install the sample tube (containing the outgassed sample) onto the analysis port and the sample
tube (containing the glass beads) onto the balance port.
5. Specify a one-point measurement (P/Po = 0.05 to 0.1) so that the initial free-space measurement
can quickly be determined; then perform the measurement.
6. Using the measured free space absolute value and the following relationship, determine the mass
of glass beads to remove from (or add to) the balance tube to reduce the free-space imbalance:
where
2.515 g/cm
3
= density of glass beads
3.53 = thermal correction (no units)
7. Use a beaker of warm water to bring the balance tube to room temperature before removing it
from the balance port of the Gemini to remove (or add) glass beads. This prevents condensation
of moisture from the laboratory atmosphere onto the cold glass beads.
8. Remove the balance tube:
• If the measured free space is negative (–), add the calculated mass of glass beads into the
balance tube.
• If the measured free space is positive (+), remove the calculated mass of glass beads from the
balance tube.
Note that the volume of one glass bead is approximately 0.014 cm
3
. Therefore, if the
measured free space is less than 0.02 cm
3
, it is unnecessary to correct the free space.