Micromeritics Gemini VII 2390a, Руководство оператора, Страница: 253 / 426

Gemini VII Performing a Blank Analysis for Diagnostic Purposes
239-42828-01 - Dec 2012 9-27
3. Select
Unit [n] > Blank Analysis
.
4. Click
Browse
to select an existing file or to create a new one. Click
Open
.
5. Click
Edit
to make and save modifications or replace all parameters in the open file using the
Replace All
button to select another file. Click
Save
and
Close
when done.
6. Click
Report after analysis
to automatically generate reports to the specified destination when
the analysis is complete. On the
Report Setting
s window, select the report destination. Click
OK.
7. Click
Start
to start the analysis. A window displays data as they are collected. A short delay is
encountered before the port status changes from the Idle state at the bottom of the screen. Review
the analysis results to see if they are within the tolerances shown in the following table. If these
results are not achieved, call a Micromeritics Service Representative.
P/Po
Tolerance in cm
3
0.1 ±0.008
0.2 ±0.010
0.3 ±0.012
0.4 ±0.014
0.5 ±0.016
0.6 ±0.018
0.7 ±0.020
0.8 ±0.022
0.9 ±0.024