Mercedes-Benz Actros 2017, Руководство по эксплуатации

Страница: 384 / 436

The permissible axle load can be found on the
vehicle identification plate.
R
the jack is designed only to raise the vehicle
for a short time, e.g. while a wheel is being
changed. It is not suitable for raising and hold-
ing the vehicle so that work can be carried out
underneath it.
R
only position the jack at the appropriate jack-
ing point of the vehicle. Make sure that the
jack is correctly positioned on the jacking
point before raising the vehicle.
The jacking point may differ on special bod-
ies. Observe the operating instructions issued
by the body manufacturer.
R
secure the vehicle before raising it to prevent
it from rolling away, e.g. by applying the park-
ing brake and/or using chocks. Do not
release the parking brake while the vehicle is
raised.
R
the surface on which the jack is standing must
be firm and level. Place the jack on an under-
lay if the surface is not firm.
R
make sure that the gap between the under-
side of the raised tyre and the ground does
not exceed 30 mm. The vehicle could other-
wise slip off the jack or tip over.
R
do not change a wheel on a slope. The vehicle
could otherwise slip off the jack.
R
do not place your hands or feet under the
raised vehicle.
R
do not lie under the raised vehicle.
R
make sure that nobody is in the vehicle when
it is raised.
R
do not start the engine and avoid jolting or
shaking the vehicle while it is raised. The vehi-
cle could otherwise slip off the jack.
X Park the vehicle on a firm and level surface.
X Apply the parking brake.
X
Use chocks to safeguard the vehicle against
rolling away.
Information on tyre pressure can be found in the
"Wheels and tyres" section (
Y
page 405).
Spare wheel
! Always use spacers to secure wheels of the
following sizes to the spare wheel bracket:
R
355/50 R 22.5
R
365/50 R 22.5
R
375/50 R 22.5
R
385/55 R 22.5
R
385/65 R 22.5
You could otherwise damage the wheel or the
spare wheel bracket.
Before fitting the wheel to the spare wheel
bracket, guide the retaining plate with the
fastening bolts though the centre of the wheel
rim. From the other side of the wheel, screw
the spacer (from the vehicle tool kit) to the
fastening bolts.
Spacer
Spare wheel (on the side of the chassis)
Clean rust and dirt off nuts
=
and bolts regu-
larly. Spray nuts
=
and fastening bolts regularly
with rust-penetrating oil.
Removing the spare wheel
X If necessary, remove the side panel or side
underride guard.
X
Assemble the hand crank and the pump lever
(vehicle tool kit) (
Y
page 371).
X Fit the pump lever and the hand crank on
spare wheel hoist
:
. Make sure that the
retaining sleeve on spare wheel hoist
:
engages in the recesses on the pump lever.
X Turn spare wheel hoist
:
until cable
;
is
taut.
X
Unscrew nuts
=
.
382
Flat tyre
Breakdown assistance