Only position the jack at the appropriate jack-
ing point of the vehicle. The base of the jack
must be positioned vertically, directly under
the jacking point of the vehicle.
G
WARNING
If you park a vehicle with pneumatic suspen-
sion and leave the ignition switched on, the
pneumatic suspension remains active. If you
then raise the vehicle using the jack, the pneu-
matic suspension attempts to compensate
the vehicle level. The jack could tip over.
There is a danger of injury.
Remove the key from the ignition lock before
raising the vehicle. This prevents automatic
readjustment of the vehicle level.
G
WARNING
Oiled, greased or damaged wheel nuts or
wheel bolt threads can cause the wheel nuts
to loosen or be damaged. As a result, you
could lose a wheel while driving. There is a risk
of an accident.
Never oil or grease the threads. In the event of
damage to the threads, contact a qualified
specialist workshop immediately. Have the
damaged wheel nuts or wheel bolts replaced.
Do not drive on.
G
WARNING
If you remove a wheel that is resting on the
wheel bolts under load, it may fall off or tip.
There is a risk of injury.
Remove the last three wheel nuts when it is
clear that the wheel is being held tension-free
on the wheel bolts.
G
WARNING
Wheel and tyre dimensions as well as the type
of tyre can vary between the spare wheel and
the wheel to be replaced. When the spare
wheel is fitted, driving characteristics may be
severely affected. There is a risk of an acci-
dent.
To prevent risks:
R
you should therefore adapt your driving
style and drive carefully.
R
never fit more than one spare wheel that
differs from the wheel to be replaced.
R
only use a spare wheel that differs from the
wheel to be replaced for a short time.
R
have a spare wheel that differs from the
wheel that has been changed replaced at
the nearest qualified specialist workshop.
You must observe the correct wheel and
tyre dimensions as well as the wheel type.
G
Warning
When, in the case of twin tyres, you are chang-
ing the outer wheel and you drive onto an
underlay with the inner wheel, the inner wheel
is then under load. In this case, the wheel
cannot be correctly pressed up against the
contact surface and tightened.
As a result, you could lose a wheel while driv-
ing. There is a risk of an accident.
When changing a wheel, always use the jack.
!
Do not raise vehicles equipped with a load-
ing crane or loading tailgate by using the
hydraulic supports. This would cause damage
to the chassis.
When changing a wheel:
R
only use wheel nuts that are approved for your
vehicle
R
note that the wheel nuts for steel and light-
alloy wheels differ
R
note that the wheel nuts for light-alloy wheels
on the front and rear axles differ
R
note that wheels with a tyre pressure sensor
have a red ring on the tyre valve
Observe the following notes when using the jack
to raise the vehicle:
R
the maximum jack payload can be found on
the sticker attached to the jack.
Before raising the vehicle, make sure that
maximum permissible axle load is not excee-
ded, e.g. by overloading.
Flat tyre
381
Breakdown assistance
Z
Содержание Actros 2017
