Mercedes-Benz Actros 2017, Руководство по эксплуатации

Страница: 367 / 436

Removing/fitting batteries
Important safety notes
! On vehicles with a battery sensor, the neg-
ative terminal clamp forms part of the battery
sensor. Tighten the negative terminal clamp
on the battery pole to a torque of 7 Nm
± 1 Nm. Otherwise, contact is not ensured
and you may damage the terminal clamp, the
battery pole or the battery sensor.
Observe the safety notes on handling batteries.
Batteries fitted one above the other
! Tighten the battery carrier screws to a tight-
ening torque of 12 Nm. Do not use a impact
wrench. Otherwise, you could damage the
bolted connection.
Batteries mounted on the side of the chassis, one
above the other (example: platform truck)
Removing
X
Remove the battery compartment cover.
X
Disconnect the negative terminal clamp first,
and then disconnect the positive terminal
clamp.
X
Detach the connecting cables between the
batteries.
X Unscrew bolts
:
from the upper battery car-
rier.
X
Pull out the upper battery carrier.
X
Unscrew bolt
;
from upper securing frame
=
.
X Remove securing frame
=
.
X
Pull out the upper battery and the upper bat-
tery carrier.
X Unscrew bolts
:
from the lower battery car-
rier.
X
Pull out the lower battery carrier.
X Unscrew bolt
;
from lower securing frame
=
.
X
Remove lower securing frame
=
.
X
Remove the lower battery and the lower bat-
tery carrier.
Fitting
X Insert the lower battery carrier.
X Set the battery onto the lower battery carrier.
X
Position lower securing frame
=
and screw in
bolts
;
.
X Push in the lower battery carrier.
X Screw bolts
:
into the lower battery carrier.
X
Insert the upper battery carrier.
X
Place the battery on the upper battery carrier.
X Position upper securing frame
=
and screw
in bolts
;
.
X
Push in the upper battery carrier.
X
Screw in bolts
:
to the upper battery carrier.
X Connect the connecting cables between the
batteries.
X
Connect the positive terminal clamp first, and
then connect the negative terminal clamp.
X Replace the battery compartment cover.
Batteries fitted one beside the other
!
Tighten the bolts of the battery support
frame to a tightening torque of 20 Nm. Do not
use an impact wrench. You could otherwise
damage the threads.
Batteries in the chassis, one beside the other
(example: tractor/semitrailer combination)
Removing
X Remove the battery compartment cover.
X
Disconnect the negative terminal clamp first,
and then disconnect the positive terminal
clamp.
Maintenance
365
Maintenance and care
Z