Manitowoc J-1300, Руководство по обслуживанию

Страница: 34 / 165

Section 3 Maintenance
3-5
Interior Cleaning and Sanitizing
GENERAL
Clean and sanitize the ice machine every six months
for efficient operation. If the ice machine requires
more frequent cleaning and sanitizing, consult a
qualified service company to test the water quality
and recommend appropriate water treatment or
installation of AuCS

accessory (Automatic
Cleaning System). If required, an extremely dirty ice
machine may be take apart for cleaning and
sanitizing.
CAUTION
Use only Manitowoc approved Ice Machine Cleaner
(part number 94-0546-3) and Sanitizer (part number
94-0565-3). It is a violation of Federal law to use
these solutions in a manner inconsistent with their
labeling. Read and understand all labels printed on
bottles before use.
CAUTION
Do not mix Cleaner and Sanitizer solutions
together. It is a violation of Federal law to use these
solutions in a manner inconsistent with their
labeling.
WARNING
Wear rubber gloves and safety goggles (and/or face
shield) when handling ice machine Cleaner or
Sanitizer.
CLEANING PROCEDURE
Ice machine cleaner is used to remove lime scale or
other mineral deposits. It is not used to remove algae
or slime. Refer to the section on Sanitizing for
removal of algae and slime.
Step 1 Set the toggle switch to the OFF position after
ice falls from the evaporator at the end of a Harvest
cycle. Or, set the switch to the OFF position and
allow the ice to melt off the evaporator.
CAUTION
Never use anything to force ice from the
evaporator. Damage may result.
Step 2 To start self-cleaning, place the toggle switch
in the CLEAN position. The water will flow through
the water dump valve and down the drain. The Clean
light will turn on to indicate the ice machine is in the
Self-Cleaning mode.
Step 3 Wait about one minute or until water starts to
flow over the evaporator.
Step 4 Add the proper amount of Manitowoc Ice
Machine Cleaner to the water trough.
Model Amount of Cleaner
Q200 Q320 Q420 3 ounces (90 ml)
Q450 Q600 Q800 5 ounces (150 ml)
Q1000 Q1300 Q1800 9 ounces (270 ml)
Step 5 The ice machine will automatically time out a
ten minute cleaning cycle, followed by six rinse
cycles, and stop.
The Clean light will turn off to
indicate the Self-Cleaning mode is completed. This
entire cycle lasts approximately 25 minutes.
Step 6 When the self-cleaning process stops, move
the toggle switch to OFF position. Refer to
“Sanitizing Procedure” on the next page.
Step 7
A. The ice machine may be set to start and finish a
self-cleaning procedure then automatically start
ice making again.
B. You must wait about one minute into the cleaning
cycle (until water starts to flow over the
evaporator) then move the switch from CLEAN
to ICE position.
C. When the self-cleaning cycle is completed, an ice
making sequence will start automatically.
Important
After the toggle switch is moved to the ICE position,
opening the curtain switch will interrupt the cleaning
sequence. The sequence will resume from the point
of interruption when the curtain switch closes.