Manitowoc J-1300, Руководство по обслуживанию

Страница: 35 / 165

Section 3 Maintenance
3-6
SELF SANITIZING PROCEDURE
Use sanitizer to remove algae or slime. Do not use it
to remove lime scale or other mineral deposits.
Step 1 Set the toggle switch to the OFF position after
ice falls from the evaporator at the end of a Harvest
cycle. Or, set the switch to the OFF position and
allow the ice to melt off the evaporator.
CAUTION
Never use anything to force ice from the
evaporator. Damage may result.
Step 2 To start self-sanitizing, place the toggle
switch in the CLEAN position. The water will flow
through the water dump valve and down the drain.
The Clean light will turn on to indicate the ice
machine is in the Self-Cleaning mode.
Step 3 Wait about one minute or until water starts to
flow over the evaporator.
Step 4 Add the proper amount of Manitowoc Ice
Machine Sanitizer to the water trough.
Model Amount of Sanitizer
Q200 Q320 Q420 3 ounces (90 ml)
Q450 Q600 Q800 Q1000 3 ounces (90 ml)
Q1300 Q1800 6 ounces (180 ml)
Step 5 The ice machine will automatically time out a
ten minute sanitizing cycle, followed by six rinse
cycles, and stop. The Clean light will turn off to
indicate the Self-Cleaning mode is completed. This
entire cycle lasts approximately 25 minutes.
If the bin requires sanitizing, remove all the ice and
sanitize it with a solution of one ounce (30ml) of
sanitizer with up to 4 gallons (15 L)of water.
Step 6 When the self-sanitizing process stops, move
the toggle switch to ICE position to start ice making
again.
Step 7
A. The ice machine may be set to start and finish a
self-sanitizing procedure then automatically start
ice making again.
B. You must wait about one minute into the
sanitizing cycle (until water starts to flow over the
evaporator) then move the switch from CLEAN
to ICE position.
C. When the self-sanitizing cycle is completed, the
clean light will turn off and a ice making
sequence will start automatically.
Important
After the toggle switch is moved to the ICE
position, opening the curtain switch will interrupt
the sanitizing sequence. The sequence will resume
from the point of interruption when the curtain
switch closes.
PROCEDURE TO CANCEL
A SELF-CLEANING OR SANITIZING CYCLE
AFTER IT HAS STARTED
If less than 45 seconds into cycle:
Move the toggle switch to the OFF position. The
cycle is now canceled.
If more than 45 seconds into cycle:
Step 1 Move toggle switch to OFF position.
Step 2 Move toggle switch to ICE position.
Step 3 Move toggle switch to OFF position.
The cycle is now canceled.