Mack M359, Руководство пользователя

Страница: 326 / 332

EMERGENCY ACTION
JUMP-STARTING ENGINE
Jump-Starting Engine
If you encounter a situation in which it is
necessary to jump-start an engine, use
the following procedures.
WARNING
Batteries which are to be linked together
must be of the same voltage (12 to 12, 24
to 24). Take care to observe proper
polarity when connecting batteries.
Batteries produce explosive gases. Keep
sparks, flames, cigarettes, etc., away from
batteries at all times. Protect your eyes by
wearing safety goggles. Be sure vehicles
are NOT touching each other.
WARNING
Remember that batteries contain a
hydrogen and oxygen mixture, which is
highly explosive. A spark which could
occur when you apply the jumper cables
incorrectly could be enough to cause the
battery to explode and injure you and
damage the truck. The battery contains
sulfuric acid, which can cause serious
chemical burns. If you get any acid in your
eyes, skin or clothes - rinse with large
quantities of water. If you get any splashes
in your eyes, contact a doctor at once.
CAUTION
The battery contains acid which is
corrosive and poisonous. It is thus
important that the battery is handled in an
environmentally compatible manner.
WARNING
Always wear eye protection when working
around batteries to prevent the risk of
injury due to contact with sulfuric acid or
an explosion.
WARNING
Battery posts, terminals and related
accessories contain lead compounds,
chemicals known to the state of California
to cause cancer and reproductive harm.
Wash hands after handling.
1 The ignition lock in both trucks
should be in position 0 (OFF).
2 Make sure that the battery system
voltage of both truck (A) and truck
(B) have the same votage. (A is 12
volt and B is 12 volt). Ensure there is
NO physical contact between trucks.
3
1 Positive Cable (Red)
2 Negative Cable (Black)
A - The truck which gives start help
B - The truck with a dead battery
4 Connect one clamp on the black
cable to the negative terminal on
truck A, (2) a large jump start nut.
5 Check that the clamps are securely
attached, so that no sparks occur.
CAUTION
Do not lean over the battery during the
start attempts, to avoid the possibility of
personal injury.
6 Start the engine in truck A. Allow the
engine to run for approximately two
minutes, at 1000 rpm, to ensure that
adequate charge for a preheater
equipped truck has been transferred
to the weak batteries.
316
X Publication_PC28