Lucent Technologies Metropolis DMXplore, Руководство по установке

Страница: 226 / 330

...........................................................................................................................................................................................................................................................
Ring Setup and Testing: Integration Procedures Overview
8 - 2 365-372-334 R2.0
Issue 4, November 2004
Tools, Test Equipment and
Accessories
Listed below are the tools, test equipment and accessories necessary to
perform the procedures in this section.
Quantity Required Description Comments
1 Y Screwdriver(s) A screwdriver(s) with the appropriate
head(s) is (are) required for securing the
mounting screws, repositioning the
mounting brackets, and installing the
interfacing cables.
1 Y ESD Wrist Strap A wrist strap must be worn when handling
circuit packs. Use the electrostatic discharge
(ESD) jack provided on the shelf.
1 N Multimeter (Optional) The voltmeter must be capable of
measuring DC voltage in the 40 to 60 volt
range. The use of the voltmeter is optional
since the shelf will alarm or shut down if the
proper voltage is not supplied.
1 Y DS1 Error Rate Test Set A DS1 error rate test set is required for
testing of DS1 cabling. A T-BERD 2209 or
equivalent is recommended.
1 Y Personal Computer (PC) See PC Minimum Requirements (page 8-3).
1 Y
CIT Interface Cable
(848748869) 8-ft. long RJ45 to 9-pin D-sub serial cable.
LAN 10BASE-T (Cross-
over) Allows for direct connection between the
PC LAN card and the CTL LAN slot. See
Table 1-17, LAN 10BASE-T Cross-over
Cable Connections (page 1-47) for
Comcode information.
LAN 10BASE-T (Straight-
Through) Allows for connection between the PC NIC
card and a HUB. See Table 1-18, LAN
10BASE-T Straight-through Cable
Connections (page 1-47) for Comcode
information.