Loepfe YarnMaster Zenit, Инструкция по эксплуатации

Страница: 25 / 83

ZENIT 25
OPERATING
Adjust process
!
The Adjust process calibrates the clearer for the
yarn to be wound. Adjust must be performed with
utmost care since it affects the clearing quality.
Example :
The yarn lot in group 1 is to be changed and the same
yarn quality is required for the yarn to be wound (same
clearer setting).
•
All spindles of group 1 must be stopped!
•
Check all clearer settings for group 1.
•
In the Edit field, tap the
Adjust
button
.
The display chang-
es to
“Start adjust” .
•
Tap the Assign button. The message “Choose a group and
assign or quit” is displayed in the info field.
•
Select group 1 with the +/– keys or via the called up key-
board.
•
Tap the Assign? button. Group 1 is now selected. (Tap the
Quit? button to interrupt the operation.)
On the Adjust button, “Adjust active (x spdl) / Stop” is displayed
with the selected number of pilot spindles of group 1.
•
Start the same number of pilot spindles as defined in the
Base Setting
menu. To ensure correct start conditions, a
cut is performed after 10 m. After a wound length of an-
other 70 m, the adjust cut is performed. This length is
needed to define the yarn count or yarn structure.
After the successful completion of the Adjust process, “Ad-
just completed / Start” is displayed on the button.
If it was not possible to successfully complete all preselected
pilot spindles, the message
“Adjust completed (x spdl) / Start”
is displayed. X stands for the number of successfully com-
pleted pilot spindles. In this case, we recommend repeating
the Adjust process.
•
To perform a check, initiate a cut at the selected pilot
spindles and allow it to wind on again. In the
Yarn Struc-
ture
menu, observe the
Act. DiaDiff%
value; it should vary
b and –. (The size of the difference depends on
the regularity of the yarn.)
!
The other spindles may be started only when the
display on the Adjust button is “
Adjust completed /
Start ”.
!
The wound yarn (80 m) could still have faults since
the clearing is not active during the Adjust process.
Display on the Adjust Button
Start adjust / Quit
The Adjust button was tapped.
•
Tap Assign button, select the group and start the pilot
spindles. The button now has “Adjust active (x spdl) / Stop”
displayed.
•
The operation can be aborted by tapping the Quit button.
Adjust active (x spdl) / Stop
The adjustment can be carried out.
•
Start the displayed number of pilot spindles.
•
By tapping the
Adjust
button, the display changes to
“Stop
adjust”.
Stop adjust / Quit
The adjustment can be cancelled.
•
If the group is now selected with Assign , the adjustment
is canceled and the display switches to “Adjust cancelled” .
•
The operation can be aborted by tapping the Quit button.
Adjust cancelled / Start
The adjustment was cancelled.
•
By tapping the
Adjust
button, the display changes to
“Start
adjust”
. The adjustment can be started.
Adjust completed (x spdl) / Start
It was not possible to successfully complete the adjustment
with all spindles.
•
By tapping the Adjust button, the display changes to “Start
adjust” . The adjustment can be repeated.
Adjust completed / Start
The adjustment was successfully completed.
•
By tapping the
Adjust
button, the display changes to
“Start
adjust”
. The adjustment can be started.
Adjust undefined / Start
It was attempted to carry out an adjustment on an undefined
group or a style.