Lite-On Technology Corp.
Industrial Automation
22
5
1000W
ISA-7-100-S1
TBD
FN 351 H-16-29
Schaffner
6
1500W
ISA-7-150-S2
-
FN 351 H-16-29
Schaffner
7
2000W
ISA-7-200-S2
-
FN 351 H-36-33
Schaffner
Clamp filter
<24V Power cable, Motor cable, Encoder cable, Interface cable>
Manufacture’s Part No. Manufacturer
A
B
C
D
ZCAT3035-1330
TDK
39 +- 1
34 +- 1
13 +- 1
30 +- 1
Installation notes
We hope that the EMI filter elaborates the maximum suppression against the interference from the
servo drive. Therefore the servo drive must be installed and wired according to the manual.
Furthermore, the following must be noted:
1.
The servo drive and EMI filter must be installed on the same metal surface.
2.
For the installation of the servo drive and EMI filter, the servo drive should be installed above the
EMI filter, if possible.
3.
The wiring must be as short as possible.
4.
Adequate earthing is required for the metal surface.
5.
The metal case or earth of the servo drive and EMI filter must be fixed firmly to the metal surface.
The contact surface between the metal case or earth and the metal area must be as large as
possible.
Selection of and installation notes for the motor wire
The selection and installation of the motor wire are associated with whether the EMI filter can
elaborate the maximum suppression against the interference from the servo drive. Note the following:
1.
The cable with copper mesh for separation must be used (double separation preferred).
2.
The copper mesh for separation on both ends of the motor wire must be grounded with shortest
distance and largest contact area.
