62
206-4341
IP Environment Setup (Cont.)
Configuring a Wired Network Connection
1. Connect the appropriate cable between the TV and the network.
2. With the Network Menu on display, use the arrow keys on the
Installer Remote to select
Network Settings
. Then, press
OK
. A
Network Settings screen (see example at right) will be displayed.
By default, the TV uses DHCP, and if a Local Area Network (LAN)
is detected, the TV will request an IP address from the DHCP
server on the network as soon as you select “Network Settings.”
If the TV is able to connect to the network, a “Connected to
Internet” message will appear below the Wired Connection
(Ethernet) field.
3. If the network is not configured for DHCP, or if you want to
enable/disable IPv6, specify static IP configuration data, or
change the network configuration from Manual to Automatic,
select
Wired Connection
(Ethernet)
and press
OK
.
In the Wired Connection (Ethernet) screen, you can change the
IPv6 status and/or edit the IP data for this TV.
4. To enable/disable IPv6, select/highlight the IPv6 field and press
OK
. Then, select
Enabled
or
Disabled
from the drop-down list
of options, as applicable.
5. To edit/specify static IP data or change the network configuration
from Manual to Automatic, use the arrow keys on the Installer
Remote to select
Edit
at the bottom of the screen and press
OK
.
Then, in the Edit screen:
• Select or de-select the “Set Automatically” checkbox, as
required. A checkmark indicates that Automatic configuration
is enabled.
• To manually edit the IP data, for each data entry field: Use
the arrow keys on the Installer Remote to select the field
and press
OK
. You can use the number keys on the Installer
Remote to direct enter numeric values or use the arrow keys to
select the appropriate alphanumeric characters (as applicable)
from the pop-up virtual keyboard displayed at the bottom of
the screen. When you are done, select
Enter
from the virtual
keyboard, and then press
OK
on the Installer Remote.
Note:
For IPv4, you must use the dot “.” key from the virtual
keyboard to separate each octet of an IP address. For IPv6,
you must use the colon “:” key from the virtual keyboard to
separate each group of an IP address.
• When all Edit fields are set as required, use the arrow keys on
the Installer Remote to select
Connect
and press
OK
.
At the top of the screen, you will see a progress display that
indicates status as each network element is confirmed.
NETWORK SETT...
Network /
Wired Connection (Ethernet)
Not Connected
Network
Pro:Centric
EDIT
Network / Network Settings / Wired Connection (...
Network
Pro:Centric
WIRED CONN...
Network / Network Settings /
Network
Pro:Centric
(Continued on next page)
DNS
DNS
Connected to Internet
IPv6
Disabled
IP (Automatic)
IP Address
10.1.2.4
Subnet Mask
255.255.255.0
Gateway
10.1.2.3
DNS Server
10.1.2.3
MAC Address
C8:08:E9:40:49:F5
CONNECT
^
EDIT
Connected to Internet
Set Automatically
IP Address
Subnet Mask
Gateway
DNS Server
10.1.2.4
255.255.255.0
10.1.2.3
10.1.2.3
