18
206-4341
This section describes the configuration options available when you select “Basic Settings” from the
First Use Wizard / Welcome screen. You can select the “BACK” button, where available, to check
previous settings, as necessary.
Note:
Each Basic Settings Wizard step is allotted a 10-second time frame after which the wizard
proceeds without user interaction. If default settings are appropriate, the wizard can proceed through
each of the configuration steps with no further user interaction. If you turn OFF the TV while the
wizard is in progress, when you turn the TV back ON, the First Use Wizard / Welcome screen will
be displayed. You will then have the opportunity to (re)initiate the desired configuration process.
Note:
To exit the wizard at any time, use the arrow keys on the Installer Remote to select/highlight
the
X
button at the top right of the screen, and then press
OK
. In the exit confirmation screen, select
EXIT
, and then press
OK
once more on the Installer Remote.
1. In the Language & Location screen, use the arrow keys on the Installer Remote to select/high-
light each appropriate field in turn—Language or Time Zone—and then press
OK
. Then, use
the up/down arrow keys to select the applicable value from the drop-down list of options for the
selected field. When you are ready to continue, use the arrow keys on the Installer Remote to
select
NEXT
, and then press
OK
.
Note:
The Country field is inaccessible/grayed out because these models are only available in
the US. Also, if you allow the wizard to progress without specifying data in this screen, the time
zone will be set for “New York” (Eastern Standard Time).
X
01
^
^
^
This wizard will continue automatically in 10 seconds.
BACK
NEXT
LANGUAGE & LOCATION
Confirm your language and location settings.
Language
English
Country
Disabled
Time Zone
New York
2. The next screen enables you to configure the network settings of the TV. Refer to the steps
below to configure a wired connection between the TV and the network. When you are ready to
continue, use the arrow keys on the Installer Remote to select
NEXT
, and then press
OK
.
Note:
If a cable is not currently connected between the TV and the network and you do not want
to configure/complete configuration of network settings at this time, you can select/highlight
SKIP
, and press
OK
on the Installer Remote to continue to the next step.
a. If not already done, connect the appropriate cable between the TV and the network.
Basic Settings Wizard
(Continued on next page)