Lenovo System x3650 M4 HD, Инструкция по установке и обслуживанию

Страница: 273 / 1168

Step 4. Pull the hard disk drives out of the server slightly to disengage them from the hard disk drive
backplane (see “Removing a hot-swap hard disk drive” on page 210).
Step 5. To obtain more working room, remove the fans (see “Removing a hot-swap fan” on page 241).
Step 6. Lift the backplane out of the server by pulling it toward the rear of the server and then lifting it up.
Backplane
Retention latch
Figure 182. Hot-swap drive backplane removal
Step 7. Disconnect all cables from the hard disk drive backplane.
If you are instructed to return the hard disk drive backplane, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Replacing the hot-swap drive backplane
Use this information to replace the hot-swap drive backplane.
Attention:
1. Before removing any components or disconnecting any cables, keep note of their respective locations
and how they are connected to the system board.
To replace the hot-swap hard disk drive backplane, complete the following steps:
Step 1. Read the safety information that begins on “Safety” on page v and “Installation guidelines”
on page 34.
Step 2. Remove the cover (see “Removing the cover” on page 195).
Step 3. Align the backplane with the backplane slot in the chassis and the small slots on top of the hard
disk drive cage.
Step 4. Lower the backplane into the slots on the chassis.
Step 5. Rotate the top of the backplane until the front tab clicks into place into the latches on the chassis.
Chapter 6
.
Removing and replacing components
261