Lenovo System x3650 M4 HD, Инструкция по установке и обслуживанию

Страница: 147 / 1168

00
0000
0000
0000
00
0000
0000
0000
0000000
0000000
0000000
0000000
000
000
000
000
UpperPCI slot error LED
Center PCI slot error LED
Lower PCI slot error LED
Figure 97. PCI riser-card LEDs
Event logs
Error codes and messages displayed in POST event log, system-event log, integrated management module
(IMM2) event log, and DSA event log.
• POST event log: This log contains the most recent error codes and messages that were generated
during POST. You can view the contents of the POST event log from the Setup utility (see “Starting the
Setup utility” on page 103). For more information about POST error codes, see Appendix B “UEFI/POST
diagnostic codes” on page 953.
• System-event log: This log contains POST and system management interrupt (SMI) events and all
events that are generated by the baseboard management controller that is embedded in the integrated
management module (IMM). You can view the contents of the system-event log through the Setup
utility and through the Dynamic System Analysis (DSA) program (as IPMI event log).The system-event
log is limited in size. When it is full, new entries will not overwrite existing entries; therefore, you must
periodically clear the system-event log through the Setup utility. When you are troubleshooting an error,
you might have to save and then clear the system-event log to make the most recent events available for
analysis. For more information about the system-event log, see Appendix A “Integrated management
module II (IMM2) error messages” on page 303.
Messages are listed on the left side of the screen, and details about the selected message are displayed
on the right side of the screen. To move from one entry to the next, use the Up Arrow (
↑
) and Down
Arrow (
↓
) keys.
Some IMM sensors cause assertion events to be logged when their setpoints are reached. When a
setpoint condition no longer exists, a corresponding deassertion event is logged. However, not all events
are assertion-type events.
• Integrated management module II (IMM2) event log: This log contains a filtered subset of all IMM,
POST, and system management interrupt (SMI) events. You can view the IMM event log through the IMM
web interface. For more information, see “Logging on to the web interface” on page 113. You can also
view the IMM event log through the Dynamic System Analysis (DSA) program (as the ASM event log).
For more information about IMM error messages, see Appendix A “Integrated management module II
(IMM2) error messages” on page 303.
• DSA event log: This log is generated by the Dynamic System Analysis (DSA) program, and it is a
chronologically ordered merge of the system-event log (as the IPMI event log), the IMM chassis-event log
(as the ASM event log), and the operating-system event logs. You can view the DSA event log through the
DSA program (see “Viewing event logs without restarting the server” on page 136). For more information
Chapter 4
.
Troubleshooting
135