LAWO edge, Руководство пользователя

Страница: 86 / 154

edge - User Manual
Version: 1.0.13/1 Exported on: 22 February, 2024 86 / 154
7.3 .edge - IP Senders and Receivers
This topic describes how to check and configure the IP senders and receivers.
Overview
Each processing blade supports a number of IP senders (and receivers) that stream content to (and from) the media
network.
The senders and receivers are pre-defined, where each one handles the three essence types of an SDI I/O: 1 x
Video, 4 x Audio, 1 Meta(data).
The total number of senders and receivers is determined by the SDI I/O configuration. For example, 24 senders + 24
receivers for a fully-licensed processing
blade.
Note that, for each converted signal, there are two sets of parameters: the sender/receiver parameters (on the IP side) and
the input/output parameters (on the SDI side). Here we deal with the former. For more information on the latter, see .edge -
SDI Inputs and Outputs
.
IP Senders and Receivers
The Senders and Receivers tabs list all of the pre-defined senders and receivers. From here, it is possible to adjust the I/O
Routing (for the audio streams), edit the streaming parameters or access the SDP data. In addition, the "Show Sidebar"
button (on the right) reveals the available properties for the selected sender or receiver. For example, for an audio essence,
you can adjust the delay or turn on the test tone.
From the main "Devices" list, click on the processing blade label (to open the "Device Details" as described earlier ). Then
select either Senders or Receivers .
IP Senders
The Senders tab lists all of the streams transmitted from the processing blade to the network. The screenshots below show
the two possible views: with the Properties sidebar turned off and on.
.edge - IP Senders (overview)