LAWO edge, Руководство пользователя

Страница: 41 / 154

edge - User Manual
Version: 1.0.13/1 Exported on: 22 February, 2024 41 / 154
•
•
Rack Requirements
To support the weight of the device, the frame must be attached to the equipment rack at both the front and rear. This is
achieved as follows.
The front of the frame attaches to the front of the rack using the mounting screws provided.
At the rear, the frame must be fitted with a rack-mounting kit (as described below).
Connectors are located at the front and rear of the unit. Therefore, when using 19-inch racks with doors please leave
enough room for the cables (and airflow).
Due to the position of the ventilation holes, it is ok to install other rack-mounted units either directly above or below
the .edge frame.
Installing the Processing Blades and I/O Plates
As standard, the frame is delivered with blanking panels to close the front and rear slots. Therefore, before mounting the
frame, you must fit the processing blades and rear I/O plates.
How to do this is described later. See Fitting a Processing Blade and Fitting a Rear I/O Plate.
Mounting Instructions
To mount the frame, please read the following important safety information and then follow the step-by-step instructions.
(E) WARNING
Please read and observe ALL of the Important Safety Instructions BEFORE installing the frame.
(F) AVERTISSEMENT
Veuillez lire et respecter TOUTES les consignes de sécurité importantes AVANT d'installer le cadre.
•
•
•
•
•
•
(E) CAUTION
The frame must be installed using one of the rear rack-mounting kits provided (to support the weight of the
device).
DO NOT install the frame into a rack with slide rails (as to do so will block the hot air outlet and prevent efficient
cooling).
Leave enough space at the front of the frame (for the connectors, cables and cold air intake).
Leave enough space at the rear of the frame (for the connectors and cables).
Leave enough space at the right side of the frame (for the hot air outlet).
DO NOT block the front or side ventilation holes.
•
•
•
•
•
•
(F) ATTENTION
Le châssis doit être installé à l'aide de l'un des kits de montage en rack arrière fournis (pour supporter le poids de
l'appareil).
NE PAS installer le châssis dans un rack avec des glissières (car cela bloquerait la sortie d'air chaud et
empêcherait un refroidissement efficace).
Laissez suffisamment d'espace à l'avant du cadre (pour les connecteurs, les câbles et la prise d'air froid).
Laissez suffisamment d'espace à l'arrière du cadre (pour les connecteurs et les câbles).
Laissez suffisamment d'espace sur le côté droit du cadre (pour la sortie d'air chaud).
N'obstruez PAS les orifices de ventilation frontaux ou latéraux.