LAWO edge, Руководство пользователя

Страница: 78 / 154

edge - User Manual
Version: 1.0.13/1 Exported on: 22 February, 2024 78 / 154
•
•
•
•
•
7.1 .edge - Controls, Connectors and Indicators
All controls, connectors and indicators are located on the front and rear panel, with the exception of the grounding screw
(10).
1. Power Supplies x 2
.edge has no on/off switch and starts automatically when power is applied.
You will hear the fans speed up when power is first applied. This is normal. The fan speed will settle once the operating
temperatures of all processing blades have been determined (by the master blade).
The processing blades take approximately 40 seconds to boot from power on.
At the end of the boot-up, each processing blade loads the latest settings (stored at shut-down).
Each power supply has two status LEDs that can be used to check the health of the PSU:
LED 1 (power) - lights in green when the power is ok.
LED 2 (fault) - lights in amber if there is a fault or warning.
The table below describes all possible states.
PSU LED Condition(s) Meaning Recommended Actions
1 - Off
2 - Off No power. No AC (or DC) input. Check the AC mains supply and IEC
connection.
(For a DC supply, check the disconnect
device/power distribution).
1 - Green
(blinking)
2 - Off Standby ON; Main output OFF;
AC (or DC) present. AC (or DC) input
detected; PSU is starting. Wait for PSU to start.
1 - Green
(solid)
2 - Off Standby ON; Main output ON.
No errors detected. PSU is active; no errors. Normal operation; no action required.
2 - Amber
(solid) Main output overcurrent,
undervoltage or overvoltage.
Fan fault or overtemperature.
Standby overcurrent or
undervoltage. Internal fault. Check the PSU Health pages (in
HOME's Advanced parameters).