LAWO edge, Руководство пользователя

Страница: 80 / 154

edge - User Manual
Version: 1.0.13/1 Exported on: 22 February, 2024 80 / 154
To identify a processing blade, either press and hold Call Home (on the unit) for at least 2 seconds or select Identify
Hardware (in HOME's General tab).
When Call Home or Identify Hardware is active, a “Says Hi” message appears in the HOME Web UI (as shown here).
To cancel the "Identify Hardware" mode, either deselect Identify Hardware (on the GUI) or press and hold the Call
Home button again (on the unit).
The Call Home button can also be used to reset the network settings for the MGMT ports. This is described later in .edge -
Network Settings.
5. Reset
The Reset button can be used to reset the power of the processing blade. The button is recessed to prevent accidental
operation. After the reboot, the blade loads the latest configuration.
You can also reboot a processing blade remotely using the Reboot option (from HOME's "Devices" list).
6. USB-C
The USB-C (port) is provided for diagnostics. In the event of a problem, you may be asked to connect this port to a service
computer by a Lawo support engineer. The connection should be made using a standard USB Type-C cable.
7. Card Status
The Card Status LED shows the health of the processing blade (and chassis*). The LED has three possible states: green,
amber or red.
Card Status LED Meanin
g Recommended Actions
Green,
intermittent Ok No action required.
Amber,
intermittent Warning Check the Card Warning(s) on the System controls page (in HOME's Advanced
parameters).
Red, blinking Fault Check the Card Fault(s) on the System controls page (in HOME's Advanced parameters).
*On the master processing blade (fitted to the highest physical slot), the Card Status LED shows the health of both the
card (blade) and chassis (frame). Typically, the chassis faults are either power or fan-related. e.g. If there is a power fault in
the frame, then the top
Card Status LED lights in red while all other Card Status LEDs are green.
8. SDI Interfaces
Each rear I/O plate is equipped with 48 x HD-BNC for SDI interfacing.
The number of available SDIs is determined by the number of ".edge_sdi" licenses on the processing blade. In addition, the
number of SDI inputs versus outputs can be changed using the Device Options (in HOME's General tab).
A processing blade can be reset to its factory default settings using the Factory page ( in HOME's Advanced
parameters).
