LAWO edge, Руководство пользователя

Страница: 39 / 154

edge - User Manual
Version: 1.0.13/1 Exported on: 22 February, 2024 39 / 154
•
•
•
•
•
•
•
•
•
•
•
•
•
5.2 .edge - Unpacking
Each .edge frame is delivered in its own box with all included accessories. If additional processing blades and rear I/O
plates have been ordered, then these are packaged separately, along with the optical
transceivers.
The license codes for all software licenses can be found on the delivery note (included with the shipment).
A list of serial numbers for the hardware components is also included. Please keep this list for your records.
Please check the contents of the shipping boxes, and in the event of any transport damage, contact your local Lawo
representative or email
support@lawo.com.
Packing List
The contents of the shipment will vary depending on the component(s) ordered. Here we describe each of the main frame
variants and .edge_gateway. For more information about how to specify a system, see .edge - Ordering Information.
Included
Packing list for .edgac+rails1 and .edgac+rails2 :
1 x .edge frame fitted with 2 x AC power su 1 x fan tray.
1 x rack-mounting kit (either 600mm or 800-900mm) - to mount the frame into the equipment rack.
2 x IEC power cables (country-specific) - to connect mains to the AC power supplies.
4 x front slot blanking panels - to close the slots at the front of the frame.
4 x rear slot blanking panels - to close the slots at the rear of the frame.
1 x Lawo toolkit - including a Torx10 driver and HD-BNC removal tool, for performing installation and service
procedures.
Packing list for .edgdc+rails1 and .edgdc+rails2 :
As above, but the frame is fitted with 2 x DC power supplies (instead of 2 x AC power supplies).
The IEC power cables are not included.
Packing list for .edge_gateway :
1 x .edge processing blade - to connect the blade to the network (and perform all SDI conversion and signal
processing).
1 x .edge rear I/O plate - to connect the blade to the external SDI and sync reference devices.
1 x .edge_sdi_inc sofware license - to activate 16 x SDI I/Os.
As a first step, the processing blades and rear I/O plates should be fitted into the frame. See Fitting a Processing
Blade and Fitting a Rear I/O Plate for instructions.
Not Included
The following items are not included and must be provided by the customer or installer:
Ethernet cable(s), optical and/or copper - to connect the media and management ports to the network switch.
Micro HD-BNC cable(s) - to connect the SDI and Reference ports to the external devices.