KTM Freeride 250 R AUS 2014, Руководство по ремонту

Страница: 84 / 222

15 WIRING HARNESS, BATTERY
82
Info
Even when there is no load on the battery, it discharges steadily.
The charge state and the type of charge are very important for the service life of the battery.
Rapid recharging with a high charging current shortens the battery's service life.
If the charging current, charging voltage, and charging time are exceeded, electrolyte escapes through the safety valves. This
reduces the battery capacity.
If the battery is depleted from starting the vehicle repeatedly, the battery must be charged immediately.
If the battery is left in a discharged state for an extended period, it will become over-discharged and sulfate, destroying the
battery.
The battery is maintenance-free, i.e., the acid level does not have to be checked.
Preparatory work
–
Remove the battery. ( p. 80)
400240-10
Main work
–
Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test the rest potential and starting ability of
the battery, and to test the alternator. With this device, you cannot overcharge the
battery.
Info
Never remove lid
1
.
Charge the battery with a maximum of 10% of the capacity specified on the
battery housing
2
.
–
Switch off the charger after charging. Disconnect the battery.
Guideline
The charging current, charging voltage, and charging time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use
3 months
Finishing work
–
Install the battery. ( p. 81)
–
Install the shock absorber. ( p. 40)
–
Lock the seat. ( p. 62)
–
Remove the motorcycle from the lift stand. ( p. 10)
15.6 Checking the charging voltage
Condition
The battery must be fully functional and completely charged.
Preparatory work
–
Raise the motorcycle with the lift stand. ( p. 10)
–
Fold the seat up. ( p. 62)
–
Remove the shock absorber. ( p. 40)
202868-10
Main work
–
Carry out the start procedure. ( p. 10)
–
Measure the voltage between the specified points.
Measuring point
Plus (+)
–
Measuring point
Ground(
−
)
Charging voltage
5,000 rpm 13.5… 15.0 V
» If the displayed value is less than the specified value:
–
Check the plug-in connections from the alternator to the voltage regulator.
–
Check the plug-in connections from the voltage regulator to the wiring har-
ness.
–
Alternator - check the battery winding. ( p. 165)
–
Alternator - check the light winding. ( p. 166)
» If the displayed value is greater than the specified value: