KTM Freeride 250 R AUS 2014, Руководство по ремонту

Страница: 100 / 222

17 LIGHTING SYSTEM, INSTRUMENTS
98
17.7 Adjusting the headlight range
Preparatory work
–
Check the headlight setting. ( p. 97)
B01043-10
Main work
–
Adjust the beam distance of the headlight by turning screw
1
.
Guideline
For a motorcycle with rider, the light/dark boundary must be exactly on the lower
mark (the mark is created in: Checking the headlight setting).
Info
Turn clockwise to increase the headlight range, turn counterclockwise to
reduce the headlight range.
A change in weight on the vehicle may require a correction of the headlight
range.
17.8 Changing the turn signal bulb
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
800137-10
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove diffuser
1
.
–
Lightly squeeze orange cap
2
in the area of the holding lugs and take it off.
–
Press the turn signal bulb carefully into the socket, turn it counterclockwise by
about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until
it stops.
Turn signal (R10W/socket BA15s) ( p. 172)
–
Mount the orange cap.
–
Position the diffuser.
–
Insert the screw and first turn it counterclockwise until it engages in the thread.
Tighten the screw slightly.
Finishing work
–
Check that the turn signal system is functioning properly.
17.9 Changing the headlight bulb
Note
Damage to reflector
Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
Preparatory work
–
Remove the headlight mask with the headlight. ( p. 67)