KTM Freeride 250 R AUS 2014, Руководство по ремонту

Страница: 99 / 222

17 LIGHTING SYSTEM, INSTRUMENTS
97
401910-01
–
Wait for the menu TIRE to flash.
Reducing the wheel circumference
–
Press the left button.
The value decreases.
Enlarging the wheel circumference
–
Press the right button.
The value increases.
Finishing work
–
Connect the speedometer connector CZ .
17.5 Setting the service display
Condition
The motorcycle is stationary.
401913-01
–
Press both buttons for 3
–
5 seconds.
The Setup menu is displayed. The UNIT display flashes.
–
Wait for the menu of the service display to flash.
–
Set the service.
Guideline
50 h
Shortening the service interval
–
Press the left button.
The value decreases.
Extending the service interval
–
Press the right button.
The value increases.
401914-01
Switching off the service interval display
–
Press and hold the left button.
off appears on the display.
17.6 Checking the headlight setting
0 0 A A
0 0 B B
400726-10
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark at a distance
B
under the first mark.
Guideline
Distance
B
5 cm (2 in)
–
Position the vehicle vertically a distance
A
away from the wall.
Guideline
Distance
A
5 m (16 ft)
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
» If the boundary between light and dark does not meet specifications:
–
Adjust the headlight range. ( p. 98)