KTM Freeride 250 R AUS 2014, Руководство по ремонту

Страница: 163 / 222

22 LUBRICATION SYSTEM
161
22.3 Filling in gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
B01670-11
Main work
–
Remove screw cap
1
and fill in gear oil.
Gear oil 0.80 l (0.85 qt.) Engine oil (15W/50) ( p. 202)
–
Mount and tighten the screw cap.
Danger
Danger of poisoning
Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. ( p. 161)
22.4 Checking the gear oil level
Info
The gear oil level must be checked when the engine is cold.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
B01669-10
Main work
–
Remove the gear oil monitoring screw
1
.
–
Check the gear oil level.
A small quantity of gear oil must run out of the drilled hole.
» If no gear oil runs out:
–
Add gear oil. ( p. 161)
–
Mount and tighten the gear oil monitoring screw.
Guideline
Screw, gear oil level check M6 10 Nm (7.4 lbf ft)
22.5 Adding gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
The gear oil level should only be added when the engine is cold.
Preparatory work
–
Park the motorcycle on a level surface.
B01669-10
Main work
–
Remove the gear oil monitoring screw
1
.