KTM Freeride 250 R AUS 2014, Руководство по ремонту

Страница: 181 / 222

27 STORAGE
179
27.1 Storage
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with
the eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with
soap and water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel.
Store fuel properly in a suitable canister and keep away from children.
Info
If you want to garage the motorcycle for a longer period, take the following steps.
Before storing the motorcycle, check all parts for function and wear. If service, repairs or replacements are necessary, you
should do this during the storage period (less workshop overload). In this way, you can avoid long workshop waiting times at the
start of the new season.
401058-01
–
When refueling for the last time before taking the motorcycle out of service, add
fuel additive.
Fuel additive ( p. 204)
–
Refuel. ( p. 61)
–
Clean the motorcycle. ( p. 177)
–
Change the gear oil. ( p. 160)
–
Check the antifreeze and coolant level. ( p. 157)
–
Check the tire air pressure. ( p. 69)
–
Remove the battery. ( p. 80)
–
Recharge the battery. ( p. 81)
Guideline
Storage temperature of battery without
direct sunlight 0… 35 °C (32… 95 °F)
–
Store the vehicle in a dry location that is not subject to large fluctuations in tem-
perature.
Info
KTM recommends raising the motorcycle.
–
Raise the motorcycle with the lift stand. ( p. 10)
–
Cover the motorcycle with a porous sheet or blanket. Do not use non-porous materi-
als since they prevent humidity from escaping, thus causing corrosion.
Info
Avoid running the engine for a short time only. Since the engine cannot
warm up properly, the water vapor produced during combustion condenses
and causes valves and exhaust system to rust.
27.2 Preparing for use after storage
401059-01
–
Remove the motorcycle from the lift stand. ( p. 10)
–
Install the battery. ( p. 81)
–
Perform checks and maintenance work when preparing the vehicle for use.
–
Take a test ride.