KTM Freeride 250 R AUS 2014, Руководство по ремонту

Страница: 29 / 222

6 FORK, TRIPLE CLAMP
27
Info
The screw cap must be screwed in all the way before the piston rod begins
to turn. In case of tight piston rod threads, it must be held to keep it from
turning. If the screw cap is not screwed in all the way, the rebound adjust-
ment will not function properly.
–
Tighten the screw cap.
Guideline
Screw cap on piston rod M12x1 25 Nm
(18.4 lbf ft)
201427-11
–
Release the special tool. Pull the spring downward and remove the special tool.
201448-10
–
Push the outer tube upward.
–
Clamp the outer tube in the area of the lower triple clamp.
Clamping stand (T612S) ( p. 214)
–
Grease the screw cap O-ring.
Lubricant (T158) ( p. 204)
–
Screw on and tighten the screw cap.
Guideline
Screw cap on outer tube M46x1 50 Nm
(36.9 lbf ft)
201449-10
Alternative 1
–
Turn the adjusting screw of rebound damping
9
and the adjusting screw of
compression damping
bk
clockwise all the way.
–
Turn back counterclockwise by the number of clicks corresponding to the fork
type.
Guideline
Rebound damping
Comfort 25 clicks
Standard 20 clicks
Sport 15 clicks
Compression damping
Standard 15 clicks
Alternative 2
Warning
Danger of accidents Modifications to the suspension settings can seri-
ously alter the vehicle's ride behavior.
–
Extreme modifications to the adjustment of the suspension compo-
nents can cause a serious deterioration in the handling characteris-
tics and overload some components.
–
Only make adjustments within the recommended range.
–
After making adjustments, ride slowly at first to get the feel of the
new ride behavior.
–
Set the adjusting screws to the position determined before removal.
–
Mount protection cap
E
.