KTM Freeride 250 R AUS 2014, Руководство по ремонту

Страница: 28 / 222

6 FORK, TRIPLE CLAMP
26
–
Mount the special tool on the cartridge.
Support tool (T14026) ( p. 212)
Info
The special tool must be used in order that the adjustment tube is not
raised. Otherwise, oil will reach the piston rod.
201443-10
–
Slide the cartridge into the inner tube.
–
Mount and tighten compression holder
8
.
Guideline
Compression holder M29x1 35 Nm
(25.8 lbf ft)
Info
If the cartridge turns as well, press the piston rod slightly to the side.
201444-10
–
Clamp the fork vertically.
–
Refill with fork oil.
Fork oil per fork
leg 390 ml
(13.19 fl. oz.) Fork oil (SAE 4) (48601166S1)
( p. 202)
Info
Pull out and push in the piston rod several times to bleed air from the car-
tridge.
201445-10
–
Remove pin
C
of the special tool.
Support tool (T14026) ( p. 212)
–
Pull out the piston rod. Mount spring. Reinstall the pin.
Guideline
Spring rate
Weight of rider: 65… 75 kg (143…
165 lb.) 4.4 N/mm (25.1 lb/in)
Weight of rider: 75… 85 kg (165…
187 lb.) 4.6 N/mm (26.3 lb/in)
Weight of rider: 85… 95 kg (187…
209 lb.) 4.8 N/mm (27.4 lb/in)
201446-10
–
Pull the spring down. Place the special tool on the hexagonal part.
Open-end wrench (T14032) ( p. 212)
–
Remove the special tool.
Support tool (T14026) ( p. 212)
201447-10
–
Clamp the special tool in the bench vise.
–
Grease the threads of the piston rod.
Lubricant (T159) ( p. 204)
–
Grease the upper edge
D
of the piston rod.
Lubricant (T158) ( p. 204)
–
Screw the screw cap with the preload spacers on to the piston rod.