KTM Freeride 250 R AUS 2014, Руководство по ремонту

Страница: 78 / 222

14 WHEELS
76
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 10)
14.6.7 Checking the chain, rear sprocket, engine sprocket and chain guide
Preparatory work
–
Raise the motorcycle with the lift stand. ( p. 10)
400227-01
Main work
–
Shift gear to neutral.
–
Check the rear sprocket and engine sprocket for wear.
» If the rear sprocket and engine sprocket are worn:
–
Change the power set.
Info
The engine sprocket, rear sprocket and chain should always be
replaced together.
400987-10
–
Pull on the upper part of the chain with the specified weight
A
.
Guideline
Weight, chain wear measurement 10… 15 kg (22… 33 lb.)
–
Measure the distance
B
of 18 chain links in the lower chain section.
Info
Chain wear is not always even, so you should repeat this measurement at
different chain positions.
Maximum distance
B
at the longest
chain section
272 mm (10.71 in)
» If the distance
B
is greater than the specified measurement:
–
Change the power set.
Info
When the chain is replaced, the rear sprocket and engine sprocket
should also be changed.
New chains wear out faster on old, worn sprockets.
B01714-10
–
Check the chain sliding guard for wear.
» If the bottom edge of the chain bolt is in line with or below the chain sliding
guard:
–
Change the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
» If the chain sliding guard is loose:
–
Tighten the chain sliding guard.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)