KTM Freeride 250 R AUS 2014, Руководство по ремонту

Страница: 90 / 222

16 BRAKE SYSTEM
88
202683-10
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Cover the painted parts.
–
Remove screws
1
.
–
Remove cover
2
with membrane.
–
Draw the old brake fluid out of the brake fluid reservoir using a syringe and fill with
fresh brake fluid.
Bleed syringe (50329050000) ( p. 206)
Brake fluid DOT 4 / DOT 5.1 ( p. 202)
202684-10
–
Mount bleeder cover
3
.
Bleeder cover (00029013018) ( p. 206)
–
Connect the bleeding device.
Bleeding device (00029013100) ( p. 206)
201494-10
–
Open shut-off valve
4
.
Info
Follow the operating instructions of the bleeding device.
–
Ensure that the inflation pressure is correctly set at pressure gauge
A
. If neces-
sary, adjust the inflation pressure at pressure regulator
B
.
Guideline
Filling pressure 2… 2.5 bar (29… 36 psi)
202685-10
–
Pull off protection cap
5
of the brake caliper bleeder screw. Connect the hose of
the bleeder bottle.
Bleeding device (00029013100) ( p. 206)
–
Open bleeder screw
6
by approx. one half turn.
Info
Bleed until fresh brake fluid emerges from the bleeder bottle hose without
bubbles.
–
Tighten the bleeder screw.
–
Close shut-off valve
4
.
–
Open the bleeder screw again until brake fluid stops emerging.
Info
This prevents overfilling of the brake fluid reservoir.
–
Tighten the bleeder screw. Remove the hose of the bleeder bottle. Mount the pro-
tection cap.
–
Disconnect the bleeding device. Remove the bleeder cover.
201894-12
–
Add brake fluid to level
C
.
Guideline
Level
C
(brake fluid level below con-
tainer rim)
5 mm (0.2 in)
Brake fluid DOT 4 / DOT 5.1 ( p. 202)
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.