KTM Freeride 250 R AUS 2014, Руководство по ремонту

Страница: 83 / 222

15 WIRING HARNESS, BATTERY
81
15.4 Installing the battery
B01688-10
Main work
–
Position positive cable
3
, and mount and tighten the screw.
Guideline
Screw, battery terminal M5 2.5 Nm
(1.84 lbf ft)
–
Position negative cable
4
, and mount and tighten the screw.
Guideline
Screw, battery terminal M5 2.5 Nm
(1.84 lbf ft)
Battery (YTX4L-BS) ( p. 172)
Info
Contact disk
A
must be mounted between screw
1
and cable lug
2
with
the claws facing down.
B01686-11
–
Position the battery in the battery compartment.
Info
Ensure that the battery cable is correctly routed.
–
Attach fastening plate
5
.
–
Mount and tighten screw
6
.
Finishing work
–
Install the shock absorber. ( p. 40)
–
Lock the seat. ( p. 62)
–
Remove the motorcycle from the lift stand. ( p. 10)
15.5 Recharging the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
Warning
Environmental hazard The battery contains elements that are harmful to the environment.
–
Do not discard batteries with the household waste. Dispose of faulty batteries in an environmentally compatible manner.
Give the battery to your authorized KTM dealer or dispose of it at a collection point for used batteries.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.